| Step | | Procedure & Parts & Tools |
| 1 |
|
EMPTY THE TANK. LOCATE THE MACHINE TOOL THAT WAS ATTACHED TO THE KEY RING OF YOUR MACHINE. THIS TOOL WILL BE USED TO OPEN THE MACHINE. IF YOU DO NOT HAVE THIS TOOL, YOU CAN USE A LONG FLAT TIP SCREWDRIVER.
|
| 1 |
|
REMOVE THE 3 SCREWS HOLDING THE CONTROL BOARD.
| Wrench-Allen metric 5.0mm |
|
|
| 2 |
|
PULL THE CONTROL BOARD DOWN TO EXPOSE THE WIRING.
|
| 2 |
|
LOCATE THE LABEL ON THE LEFT SIDE OF MACHINE (STANDING IN OPERATOR POSITION). FOLLOW THE DIRECTIONS ON THE LABEL TO OPEN THE MACHINE.
|
| 3 |
|
FOLLOWING THE DIRECTIONS ON THE LABEL, INSERT THE MACHINE TOOL INTO THE MACHINE. LIFT UP ON TANK TO OPEN MACHINE.
|
| 3 |
|
LOCATE THE 2 WIRES THAT ARE LABELED DR(DRIVE MOTOR RIGHT) AND DL (DRIVE MOTOR LEFT). CHECK WIRE CONNECTORS FOR A TIGHT CONNECTION. VISUALLY INSPECT THE WIRES FOR DAMAGE SUCH AS, CUTS, CRACKS AND/OR EXPOSED WIRES. IF WIRES ARE OKAY, REVERSE STEPS 1 AND 2 TO REASSEMBLE THE MACHINE.
|